Difference between revisions of "InContext Server Installation"

From Lingoport Wiki
Jump to: navigation, search
(Install)
(Install)
Line 1: Line 1:
   
  +
== Checking InContext Server Installation ==
== Install ==
 
 
If the G11n system was installed using the Lingoport Stack Installer or the Lingoport Stack Updater, then the InContext Server should have been installed at that time. To check:
 
If the G11n system was installed using the Lingoport Stack Installer or the Lingoport Stack Updater, then the InContext Server should have been installed at that time. To check:
   

Revision as of 19:32, 26 April 2019

Checking InContext Server Installation

If the G11n system was installed using the Lingoport Stack Installer or the Lingoport Stack Updater, then the InContext Server should have been installed at that time. To check:

$sudo systemctl status incontext-server

and output:

● incontext-server.service - InContext Server Service
  Loaded: loaded (/etc/systemd/system/incontext-server.service; disabled; vendor preset: disabled)
  Active: inactive (dead)

If the output says something about the service not found, then it needs to be installed following the Installation Steps below.

If the service exists, then proceed to the Running the InContext Server below and start the service.

InContext Server Installation Requirements

The InContext Server requires the following:

  • Java 8
  • MySQL 5.5.3+

Since the Lingoport Suite already requires Java and MySQL, the only additional requirement for the InContext Server is Tomcat. The InContext Server provided by Lingoport installs Tomcat 8.5.x.

InContext Server Files

There are three files that comprise the InContext Server. The Lingoport InContext Server automated installation process will put these files in the appropriate location.

  • incontext-server.war
  • incontext-server.sh
  • IncontextServerConfig.groovy

The incontext-server.war is the server itself and must be placed under the tomcat/webapps directory.
The incontext-server.sh file is a script for starting/stopping the InContext Server and must be configured and placed in the tomcat directory.
The IncontextServerConfig.groovy file is the configuration file for the InContext Server and must be configured and placed in the tomcat directory.

Installation Steps

1. Download and unzip the IncontextServer-<version>.zip file from our SFTP site.

2. Change directory: cd incontext-server

3. Modify install.conf to set the values required by the install. Any information left blank will be prompted by the install script.

  • MYSQL_ROOT_PASS - this is the password that was used or created by the Stack Installer or Stack Updater.
  • INCONTEXT_MYSQL_USER / INCONTEXT_MYSQL_PASS - this is a new MySQL username and password.
  • INSTALL_TOMCAT_HERE='/usr/local/tomcat' - Unless there is reason to change the location, leave it at the default.

4. Run the install script (note you must have sudo privileges): ./install.sh. If it is successful, one should see:

Incontext Server successfully installed.

Running the InContext Server

To start the InContext Server:

$sudo systemctl start incontext-server

Then browse to: http://yourserverurl:8081/incontext-server

InContextServerLogin.jpg


To stop the InContext Server:

$sudo systemctl stop incontext-server

To check the status of the InContext Server:

$sudo systemctl status incontext-server

Next Steps

To continue installing InContext for Translation go to: InContext Capture Installation

For information on how to proceed after installation, please see the: InContext Server Users Guide