On Boarding a Globalyzer Project

Before On Boarding a Globalyzer Project

To on-board any project, a number of basic information is needed:

Code Repository Location

• The code repository location and branch for the project.
• Git locations could look like: https://github.com/group/project ; In addition, the branch for the Git project is needed
• SVN locations could look like: https://svn.group.com/project/trunk
• Read and Write Access granted to repository

Globalyzer Scan Information

• The directories and files to be scanned
• The rulesets to be used to scan the source code.
• A Globalyzer Project file is created with this information and put in the code repository.

On Boarding the Globalyzer Automation Job

Jenkins

Create the Jenkins job

To begin the on-boarding process, go to Jenkins, and select the 1-Automation Tab, and New Item

• Make a copy of Lingoport.SampleLite
• Set the name of the new job to <groupname>.<projectname>
• Make sure Add to current view is checked and select OK

Configure the Jenkins job

General

• General section: Select the GitHub project and fill in the Project url
• Throttle Concurrent Builds should be checked.
• Throttle this project as part of one or more categories
• LRM Throttle should be checked.

Source Code Management

Source Code Management section: Set up the Repository, Credentials, and Branch

Build Triggers

These are left unchecked by default, but the Build Periodically can be set to build on a repeating basis.

Build Environment

Leave these unchecked.

Post Build Actions

• Nothing needs to be modified in this section

Select the Save button. Enable the project and Build Now. The Jenkins project should run and push the results to the Lingoport Dashboard.

For more information, see Project Configuration Files